You are watching: 2004 honda crv fuel filter location
Engine mechanically problem2001 Honda CRV 4 cyl four Wheel journey Automatic 113000 mile ns would like to recognize where is the fuel filter situated
Engine performance problem2002 Honda CRV 4 cyl four Wheel journey Automatic 115000 mile I require to recognize where the fuel filter is located.Thank girlfriend
Service and also Repair note The fuel filter must be changed whenever the fuel pressure drops below the stated value (270 - 320 kPa, 2.8 - 3.3 kgf/sq.cm, 40 - 47 psi) , ~ making certain that the fuel pump and also the fuel push regulator room OK.Remove the fuel pump.
eliminate the fuel filter (A). Download in the reverse order the removal with a brand-new base gasket (B) and also a brand-new O-ring (C), then inspect these items:When connecting the cable harness, make certain the connection is secure and the terminal (D) is steady locked into place. As soon as installing the fuel gauge sending unit (E), make certain the link is secure and the connector is steady locked right into place. Be mindful not to bending or twist it excessively.
my 2002 Honda CRV 4wd shuts down as soon as I come to a stop. It no longer idles. I can quickly start that again and as long as I save the RPMs up, the automobile functions fine. Is this a fuel pump issue?
Clean out the idle air control valve, test the throttle position and also manifold absolute press sensors-to encompass a fuel press check-
Engine mechanical problem2001 Honda CRV 6 cyl every Wheel drive Automatic Hey how long go it take it to perform this, you need to drop the tank ns assume right?
See more: What Is Vac In Electrical Terms ? What Does Vac Stand For In Electrical Terms
Fuel Pump/Fuel Gauge sending out Unit Replacement unique Tools compelled Fuel sender wrench 07XAA-001010A1.Relieve the fuel pressure. 2.Remove the fuel to fill cap. 3.Fold the rear seats forward, and pull back the carpet to expose the access panel.
4.Remove the access panel (A) native the floor. 5.Disconnect the fuel pump 5P connector (B). 6.Disconnect the quick-connect installation (C) from the fuel tank unit.
7.Using the special tool, ease the fuel tank unit assembly locknut (A).
8.Remove the locknut (A) and the fuel tank unit. 9.Remove the fuel filter (B), the fuel gauge sending unit (C), the instance (D), the cable harness (E), and the fuel press regulator (F). 10.When connecting the fuel tank unit, make certain the link is secure and the suction filter (G) is firmly associated to the fuel pump (H). 11.Install the fuel tank unit in the turning back order the removal through a brand-new base gasket (I) and new O-rings (J). Be certain to examine these items: *When connecting the wire harness, make sure the link is secure and also the connector (K) is firmly locked into place. *When installing the fuel gauge sending out unit, make certain the link is secure and the connector is steady locked into place. Be mindful not to bending or twist it excessively. *When installing the fuel tank unit, align the clues (L) top top the fuel tank (M) and also the fuel tank unit (N).https://www.y2kcenter.org/kpages/auto_repair_manuals_alldata.htm